Scosche CJ1282B Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
1985-89 Chrysler Le Baron GTS
1985-89 Dodge Lancer
Radio Removal:
1. Remove eleven screws from the perimeter of the
dash trim panel and remove the trim panel.
2. Remove two anti-theft bolts (use Snap-On bit
TTW12 for 1/4" drive) which secure the radio to
the dash substructure; pull the radio out of the
cavity, disconnect all wiring, and remove the radio.
1989-95 Chrysler Le Baron GTC Convertible
Radio Removal:
1. Gently pry outward on the radio trim bezel to
release seven snap clips and remove.
2. Extract two hex head bolts holding radio in place
and slide radio outward.
3. Unplug all power/speaker connectors, unplug
antenna and unbolt ground strap-remove radio.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
16
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
1987-96 Dodge Dakota
Radio Removal:
1. Remove eight screws from the dash trim
panel.
2. Remove two screws from the underside of
the steering column trim, and remove the
trim.
3. Remove two screws from the radio
mounting bracket, disconnect power
antenna, speaker leads, and all other
electrical connections, and remove the
radio.
Radio Removal:
1. Reach behind ashtray and unsnap the carrier
housing to remove the ashtray.
2. Remove three screws along the top edge of the radio
trim panel.
3. Remove two screws below the radio trim panel.
Remove the trim panel.
4. Remove two screws securing the radio to dash then
pull the radio out.
5. Disconnect the power, antenna, and all speaker and
electrical connections. Remove the radio.
1990-93 Dodge Daytona
Read pages 2-3 for kit assembly.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments