Scosche CJ1282B Manual download pdf (Page 8)

1987-93 Chrysler Le Baron "Coupe"

Radio Removal:

1. Remove two screws, one from each lower corner of the

radio/console trim panel.

2. Gently snap off the trim panel.

3. Remove two screws securing the right side panel of the

console, one at top, one at bottom; remove the side

panel.

4. Remove two screws from the radio mounting

bracket. Disconnect the wire harness, antenna lead,

and ground strap. Remove the radio.

Read pages 2-3 for kit assembly.

USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.

FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.

1982-83 Chrysler Le Baron

1981-84 Dodge Aries

1982-83 Dodge 400

1981-83 Plymouth Reliant

Radio Removal:

1. Remove four screws from the top of the radio

panel trim and four from the bottom of the panel

trim. Remove the panel.

2. Remove two bolts retaining the radio, and remove

the radio. Disconnect the power, ground cable,

antenna and speaker wires.

Read pages 2-3 for kit assembly.

USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.

FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.

USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.

FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.

USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.

FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.

1998-00 Dodge Durango

Radio Removal:

1. Extract (3) screws from the bottom edge of small

center plastic panel below steering column, pry out

on panel to remove.

2. Use a panel removal tool to carefully pry out on the

radio/dash panel, unsnap, unplug the left side of the

panel, and remove.

3. Extract (2) 10MM bolts holding radio in, unplug and

remove radio.

Read pages 2-3 for kit assembly.

Read pages 2-3 for kit

assembly.

1995-99 Dodge Neon

1995-99 Plymouth Neon

Radio Removal:

1. Remove the ashtray from the dash.

2. Carefully pry outward on the radio trim bezel to

release spring clips then remove.

3. Extract the two 3/8" screws securing the radio

to the dash, pull the radio from the dash cavity,

unplug all connectors, disconnect the ground

strap and remove the radio.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Scosche CJ1282B Manual Page 8

Comments to this Manuals

Related products and manuals for Mounting kits Scosche CJ1282B