2
CAUTION:
Disconnect your vehicle's negative battery
terminal before the installation to help
prevent electrical damage. We recommend
the use of a volt/ohm meter over a test light
to check wiring. A test light or grounded
wire probe can cause damage to the
vehicle's computer and/or diagnostic
systems. Avoid all factory airbag wiring.
Airbags can accidentally deploy causing
serious injury or death.
INTRODUCTION
The Scosche In-Dash Installation Kit for 1974-UP Chrysler and Jeep Vehicles provides the parts you need to
mount your car stereo/cassette player into your vehicle's dash. Refer to the individual instructions in this
manual to remove your vehicle's factory installed radio.
PRELIMINARY PARTS LIST
Use the shaded mounting tabs and indicated brackets. Carefully break or
cut off the unused brackets. Then assemble the radio and the mounting
panel as shown below, and secure the kit to your dash using the supplied
screws. Reassemble your dash, and attach the radio's front panel and
controls.
The following example shows a typical installation.
ASSEMBLING THE KIT
The instructions for each vehicle show which mounting panel and brackets to use.
DIN RADIO
RADIO'S
MOUNTING
SLEEVE
CJ1279/CJ1282
MOUNTING
PANEL
IN-DASH DIN PULLOUT, DETACHABLE
FACEPLATE, (DIN-E) RADIOS
The kit panel comes DIN ready. Follow the instructions
supplied with the radio, secure the mounting kit. Install
the assembly in the dash and use the rear support
strap supplied with the radio to support the rear of the
radio.
CAUTION:
REAR SUPPORTING THE RADIO
ADDS TO THE INSTALLATION'S
STRUCTURAL INTEGRITY.
REAR
SUPPORT
STRAP
NOTES:
• See your vehicle's instructions for any special
tools your installation might require.
• Read all instructions accompanying your car
stereo/cassette player for proper wiring and
mounting instructions.
CJ1279
CJ1282
ISO BRACKETS
KIT PANEL
TRIM RING
KIT PANEL
23
Read pages 2-3 for kit assembly.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
1997-01 Jeep Wrangler
Radio Removal:
1. Extract (2) screws from dash bezel.
2. Pry on bezel to release spring clips and remove.
3. Extract (2) screws holding radio, unplug and remove.
1989-95 Plymouth Acclaim
Radio Removal:
1. Carefully release the spring clips securing the radio/
dash trim: three clips along the top and two at the
bottom. Disconnect the panel light and remove the
trim piece.
2. Extract the two bolts securing the
radio: one at the top right, and one at
the bottom left of the radio.
3. Pull the radio out of the dash cavity,
disconnect the antenna and all
electrical connections, and remove the
radio.
RADIO'S
SUPPLIED
TRIM PLATE
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals