5
1975-79 Chrysler Cordoba
1975-77 Plymouth Fury
Read pages 2-3 for kit assembly.
Radio Removal:
1. Remove four securing screws from the bottom edge of the
radio dash panel.
2. Remove two securing screws from the top edge of the
panel above the radio.
3. Unscrew the retainer ring securing the remote mirror
control and remove the panel.
4. Remove two screws securing radio to the dash. Pull the
radio out.
5. Disconnect power, antenna and all speaker and electrical
connections.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Radio Removal:
1. Remove nine securing screws from the top and bottom of the
radio trim panel. Remove the panel by pulling it down and out.
2. Unhook the wiring harness.
3. Remove the two Chrysler anti-theft bolts retaining the radio
(use Snap-On bit TTW 12 for 1/4" drive) and remove the
radio. Disconnect power, ground cable, antenna and speaker
wires.
1983-84 Chrysler E Class 1983-88 Dodge 600 ES
1984-88 Chrysler Le Baron 1985-89 Dodge Aries
1984-87 Chrysler New Yorker 1985-89 Plymouth Reliant
Read
pages 2-3
for kit
assembly.
20
1987-94 Dodge Shadow
1987-94 Plymouth Sundance
Radio Removal:
1. Remove the ashtray
2. Carefully pull outward on the edges of the trim panel to release
the snaps, and remove the panel.
3. Remove one retaining screw from above the right upper corner
of the radio.
4. Pull the dash trim towards the passenger side to gain access
to the upper right radio bolt; remove the top right bolt and
the lower left bolt.
5. Pull out the radio. Disconnect the power, antenna, speaker
leads, and all other electrical connections. Remove the radio.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Radio Removal:
1. Remove two screws securing the dash panel inside the glove box.
2. Remove four screws from the bottom edge of the dash panel
and one on the left side of the panel.
3. Carefully pull the panel from the dash and remove the
panel.
4. Remove two screws securing the radio to the dash. Pull the
radio out.
5. Disconnect power, antenna, and all speaker and electrical
connections.
1978-01 Dodge Ram Van
1978-83 Plymouth Van
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals