DIN TRIM
RING
DIN
RADIO
RADIO'S
SLEEVE
FD1327
MOUNTING
PANEL
POCKET INSTALLATION
POCKET INSTALLATION
1. Locate and align bottom guides and top snaps of the pocket to kit panel.
2. Slide pocket on bottom guides while the top snaps are aligned.
3. When aligned properly the top pocket snaps will lock to kit panel.
KIT INSTALLATION
STEREO INSTALLATION
1. See Illustration "A" for kit assembly with DIN or Illustration "C" for Shaft stereos.
2. Be sure to attach rear support bracket provided in the installation kit to the back as shown in Illustrations
"A" and "C".
3. Connection the stereo to the factory wiring as directed in the stereo's owners manual. Scosche
recommends the use of an FD02/FD16 connector set when connection to the factory wiring. The FD02/
FD16 connector will plug into the wiring in the vehicle and eliminate the need to cut and splice into the
factory wiring.
ILLUSTRATION "A"
DIN RADIOS:
The kit comes DIN ready.
Following the instructions
supplied with the radio,
secure the radio to the
mounting kit.
VARIOUS REAR
SUPPORT STRAP
SAMPLES
1997-04 Ford Club Wagon
1995-04 Ford Crown Victoria
1997-04 Ford Econoline
2001-05 Ford Escape
2000-04 Ford Excursion
1995-01 Ford Explorer 2/4 DR
2001-03 Ford Explorer 2 DR Sport
2001-03 Ford Explorer Sport Trac
1999-03 Ford F-Series Super Duty
Pickup
1995-03 Ford Ranger
1999-03 Ford Windstar
1995-97 Lincoln Continental
1995-98 Lincoln Mark VIII
1995-04 Lincoln Town Car
1995-03 Mazda B-Series
Pickup
2001-03 Mercury Cougar
1995-03 Mercury Grand
Marquis
1996-01 Mercury Mountaineer
1999-03 Ford Expedition
1999-03 Ford F-Series Pickup
2004 Ford F-Series Pickup Heritage
2002-03 Lincoln Blackwood
1998-04 Lincoln Navigator
USE THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
RADIO REMOVAL:
1. Carefully pry out on radio/
dash bezel and unsnap to
remove.
CAUTION: PASSENGER
AIRBAG SWITCH DOES
NOT UNPLUG ON PICKUP.
2. Insert DIN Removal Tools,
spread the tools apart to
release factory stereo, slip it
out of the dash and remove
radio.
USE THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
RADIO REMOVAL:
1. Insert DIN Removal Tools,
spread the tools apart to
release factory stereo,
slip it out of the dash,
unplug and remove radio.
BACK VIEW OF
MOUNTING PANEL
BACK VIEW
OF POCKET
2 3
NOTE:
REAR SUPPORT
AVAILABLE
SEPARATELY. REAR
SUPPORTING THE
RADIO ADDS TO
THE INSTALLA-
TIONS STRUCTURAL
INTEGRITY.
USE
BRACKETS "A"
USE
BRACKETS "A"
USE BRACKETS "B"
USE
BRACKETS "B"
USE
BRACKETS "B"
(8 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals